|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
;
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
WALL-MOUNTING
The Infinity Alpha 25ES speaker is designed to mount directly to a wall. Each speaker has (4) keyholes in the rear to allow either left- or right-side placement. Each speaker will require (2) 1-1/2," #8 wood screws fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2," #8 screw. Use the supplied template to accurately position the screws on the wall and refer to the diagrams for more assistance. NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers. Step 1. Position the supplied wall-mount template on the wall in the desired speaker location. Make two markings per speaker. IMPORTANT NOTE: The set of drivers that the arrow in Figure 3 points to should be installed toward the front of the room. It does not matter whether or not the tweeter is positioned above or below the woofer. This will ensure proper operation and performance should the Monopole or Dipole position on the surround mode configuration switch be selected.
FIGURE 7
6-5/8" 3-5/16"
®
Alpha25es
Nominal Inpedance: 8 ohms Designed and Engineered by Infinity Assembled in Mexico
14-1/2"
Serial: Infinity Systems, Inc. Northridge, California A Harman International Company
Step 2. Fasten (2) 1-1/2," #8 wood screws to the wall using the markings placed in Step 1 as your guide. Leave a 3/16" space between the wall and screwhead. If a wall stud is not available, use an appropriate anchor. Step 3. Attach speaker wire, as shown on page 5. Step 4. Place the speaker on the wall by aligning the upper two keyholes on the back of the speaker to the screwheads on the wall. Once positioned properly, the speaker should slide down slightly and become secure.
4
Infinity Alpha 25ES
|
|
|
> |
|
|
Parse Time: 0.18 - Number of Queries: 112 - Query Time: 0.036
